In the majority of cases, most people spend quite a lot of money purchasing their lift truck. Therefore, it is extremely important to take proper care of it so as to protect your investment well into the long run. It is a great idea to know the procedures that are undertaken in the maintenance and care of this piece of machinery.
By starting up the forklift and listening closely how it runs is amongst the best ways to tell how good the engine is running. Like for example, if there are any misses or knocks, the equipment is defective and this should raise some issues. Moreover listen carefully for any squealing sounds which come from the belts because these sounds would provide you with a wealth of information.
When performing maintenance, several of the main components you would have to pay attention to consist of the safety warning devices, horn, the lights, the gauges and the overhead guard. Any burnt out light bulbs or faulty parts should be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals must be cleaned when the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery must be inspected in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter have to be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Next, inspect every other component of the machinery like the wheels. If any type of fault or concern is detected, be sure to deal with it immediately so as to make sure the equipment is running at its safest and optimum levels.