Change a Propane Tank
Forklifts fueled by propane are common inside warehouse settings. These forklifts have a propane mount situated at the rear of the operator. These tanks need to be replaced periodically since they have limited lifespans. Forklift operators must use care when handling propane tanks. Compressed gases are hazardous, especially since the gas is flammable. Utilize care when removing and replacing propane tank to avoid being injured.
1 To change a propane tank, first stop the lift truck while leaving the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This process burns off the gas inside the transfer hose which connects the tank and the engine. Before taking the next steps, put on the proper safety equipment, like insulated gloves made of either leather or neoprene. It is really essential for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, reattach the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 You could check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to foam around the value. If this happens, check the connection hose at the nut and the valve area. The connecting nut should be re-tightened if you detect any leaks in the valve area, and afterward perform the leak checking procedure again. Persistent leaks mean that both the connecting hose and nut should be replaced. However, if replacing the hose and nut still does not stop the leak, the tank will have to be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Then you can start the forklift and continue operating.